Table of Contents
Advertisement
Quick Reference Guide
2.
F
RONT PANEL CONTROLS
WARNING
ALL EQUIPMENT INVOLVED IN THE INSTALLATION TASK MUST BE INSTALLED
CORRECTLY AND SWITCHED OFF
WITH THE INSTALLATION TASK
U
NSAFE CIRCUITS AND INSTALLATIONS CAN CAUSE
.
DAMAGE TO EQUIPMENT
For the location and availability of the basic front panel controls, please
refer to the front panel as shown on the packaging. If available, the basic
front panel controls are:
To switch to standby or on.
Note that the ON/OFF switch is located on the rear panel.
to go to the main menu;
to go back one menu
to move the cursor
to go one channel up or down.
to go to the (favorites) lists;
to make a menu selection;
to confirm a selection.
to leave a menu or feature;
to zoom in on live video.
Indicators
The green indicator shows that there is sufficient signal
received
The red indicator shows that the receiver is in standby
The orange indicator shows that a RCU command is
received.
Access door to access the different slots for the CI-modules and
smartcards.
Page 2
. M
AKE SURE THAT IT IS SAFE TO PROCEED
.
(
)
SERIOUS
INJURY OR
;
3.
R
EAR PANEL CONNECTIONS
For the location and availability of the connectors, please refer to the rear
panel as shown on the packaging. If available, the connectors on the rear
panel are:
For each tuner (LNB1, LNB2)
LNB IN (F-type), to connect a dish installation;
IF OUT (F-type), for a loop through connection to another
receiver/tuner.
RS-232 (sub-D), to connect to the serial communication
port of a PC.
TV (SCART), to connect to a TV with a fully-featured
SCART cable;
VCR (SCART), to connect to a VCR with a fully-featured
SCART cable to enable RGB loop-though for DVD players.
SVHS (DIN), to connect to a S-Video input of SVHS
compatible equipment.
(White)
AUDIO L (RCA), to connect to the left audio input of a
stereo set.
(Red)
AUDIO R (RCA), to connect to the right audio input of a
stereo set.
(Yellow)
VIDEO (RCA), to connect to the composite video input of
the TV (monitor).
(Black)
0/12V (RCA), to connect a remote 0/12V switch.
ANT IN (IEC), to connect to a VHF/UHF terrestrial
TV antenna;
TV OUT (IEC), to connect to the UHF connector of a TV or
a VCR.
S/PDIF (TOSLINK), to connect to a Dolby Digital (AC-3)
compatible audio equipment.
USB (USB-B), to connect to an USB compatible PC.
ON/OFF switch, to switch the receiver ON or OFF.
EchoStar International Corporation
Advertisement
Table of Contents
