AUTODOME IP 4000i
3.1.4
AUX Control
With the tab AUX Control you can enter pre-programmed keyboard control commands. These
commands are composed of a command number plus the appropriate function key (Show pre-
position, Set pre-position, AUX on, or AUX off). A valid combination either issues a command
to the device or displays an on-screen menu.
(Refer to the "AUX Commands" section of the manual for a list of all AUX commands for your
camera.)
Show pre-position
Click this button to display a pre-position.
Set pre-position
Click this button to set a pre-position.
AUX on
Click this button to activate an AUX command.
AUX off
Click this button to deactivate an AUX command.
3.1.5
Digital I/O
(only for cameras with alarm connections)
Depending on the configuration of the unit, the alarm input and the output are displayed next
to the image. Expand the Digital I/O group if necessary.
The alarm symbol is for information and indicates the status of an alarm input:
–
The alarm output allows the operation of an external device (for example, a light or a door
opener).
–
Input 1
This parameter identifies the first alarm input.
Input 2
This parameter identifies the second alarm input.
Output 1
Click the checkmark icon to enable the output. The checkmark becomes green.
Note: You can change the name of an alarm input in Configuration > Interfaces > Alarm
Inputs > Input 1 (or Input 2) > Name.
You can change the name of an alarm output in Configuration > Interfaces > Alarm Outputs >
Output name.
3.1.6
Special Functions
Tour A / Tour B
Click one of these buttons to start the continuous playback of a recorded (guard) tour. A
recorded tour saves all manual camera movements made during the recording, including its
rate of pan, tilt and zoom speeds, and other lens setting changes.
To stop a tour, click a directional control in the View Control tab.
Focus
Click this button to activate the Auto Focus One Push mode on the camera.
The OSD displays the message, "Auto Focus: ONE PUSH."
Bosch Security Systems
The symbol lights when the input alarm is active.
To activate the output, click the checkmark symbol.
–
The symbol lights when the output is activated.
User Manual
Operation via the browser | en
2020-06 | 2.0 |
11