Connecting A Usb Device; Connecting Other Portable Audio Device; Listening To The Radio - Alpine CDE-203BT Owner's Manual

Connecting a USB Device

1
Turn down the volume on the unit.
2
Connect the USB device to the unit.
To connect an iPod/iPhone, use the USB
connection cable for iPod (not supplied).
(CDE-203BT/ UTE-200BT only)
Connecting Other Portable Audio
Device
1
Turn off the portable audio device.
2
Turn down the volume on the unit.
3
Connect the portable audio device to the
AUX input jack (stereo mini jack) on the
unit with a connecting cord (not
*
supplied) .
* Be sure to use a straight type plug.
4
Press SOURCE
To match the volume level of the
connected device to other sources
Start playback of the portable audio device at a
moderate volume, and set your usual listening
volume on the unit.
Press and hold /SETUP for at least 2 seconds,
then select [AUDIO]
12
-EN
to select [AUX].
[AUX VOL] (page 21).

Listening to the Radio

Listening to the Radio
To listen to the radio, press SOURCE
[TUNER].
Storing automatically
1
Press /A.ME to change the band (FM1,
FM2, FM3, MW or LW).
2
Press and hold
seconds.
The unit stores stations in order of frequency
on the number buttons.
Tuning
1
Press /A.ME to change the band (FM1,
FM2, FM3, MW or LW).
2
Perform tuning.
To tune manually
Press and hold
approximate frequency, then press
repeatedly to finely adjust to the desired
frequency.
To tune automatically
Press / .
Scanning stops when the unit receives a
station.
Storing manually
1
While receiving the station that you want
to store, press and hold a number button
(1 to 6) until [MEM] appears.
Receiving the stored stations
1
Select the band, then press a number
button (1 to 6).
to select
/A.ME for at least 2
/ to locate the
/