Table of Contents
Advertisement
WARNING
USE COPPER CONDUCTORS ONLY
1 - Disconnect all power supplies.
2 - Remove the air handler access panel.
3 - Route the field supply wires to the air handler
electrical connection box.
4 - Use wire nuts to connect the field supply conductors
to the unit black and yellow leads, and the ground
wire to ground terminal marked GND.
5 - 5. Replace the air handler access panel.
SIDE
FIGURE 15. Electrical Connections
(Upflow Configuration)
NOTE - To avoid the possibility of moisture damage to the
control in some right-hand discharge configurations, the
control panel can be relocated to the end panel as shown
in figure 16.
FIGURE 16. Control Panel Relocated to End Panel
TOP
Page 13
TOP
SIDE
(Left-Hand Horizontal Configuration)
WARNING
Electrically ground air handler. Connect
ground wire to ground terminal marked
"GND".
Failure to do so can result in death or
electrical shock.
Advertisement
Table of Contents
