Table of Contents
Advertisement
When navigating through the configuration process using the Rinnai Touch
App, eventually a screen like that shown will be displayed that lists all the Wi-Fi
Router SSIDs that have been detected by the Touch Wi-Fi Module along with
IMPORTANT
a symbol indicating the strength of the Wi-Fi signal as seen by the Touch Wi-Fi
Module.
Symbol Colour
•
If the Wi-Fi Router SSID required is not listed then the Touch Wi-Fi
Module could not detect it so the Touch Wi-Fi Module must be relocated.
•
If the Wi-Fi Router SSID required is listed but with a RED symbol
indicator then it is recommended to relocate the Touch Wi-Fi Module.
On relocating the Touch Wi-Fi Module ensure power is cycled to it as a scan
of all available Wi-Fi Router SSIDs is only done by the Touch Wi-Fi Module on
power up. The Touch App will also have to be restarted.
IMPORTANT
Once configured to connect to the chosen Wi-Fi Router the Touch Wi-Fi Module
will have its Wi-Fi indicator flashing green.
NOTE
A short duration blinking of the Wi-Fi indicator indicates the Touch Wi-Fi Module
has connected successfully to the Wi-Fi Router selected.
NOTE
Rinnai
GREEN
YELLOW
RED
Poor (Possible Intermittent Connection)
Signal Strength
Excellent
Good
15
CONFIGURE MODULE
Select your Wi-Fi Router SSID
from the list below which have
been detected by the Touch
Wi-Fi Module:
Available Networks
Sample WiFi
Telstra Air
HOTSPOT
AndroidAP
NOT DETECTED
NEXT
PWR BUS
WiFi
SER
Wi-Fi Indicator
Touch Wi-Fi Kit IM
Advertisement
Table of Contents
