Adjusting Boat Trim - Yamaha F300 Owner's Manual

Operation
angle can cause loss of control.
If equipped with a power trim and tilt
●
switch located on the bottom cowling,
use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
switch while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
UP
1
DN
UP
1
DN
UP
1
DN
1
78
ZMU06259
ZMU05834
UP
ZMU05835
DN
UP
1
DN
1
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
" " (up).
To lower the bow (trim-in), press the switch
" " (down).
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EMU27911

Adjusting boat trim

When the boat is on plane, a bow-up attitude
results in less drag, greater stability and effi-
ciency. This is generally when the keel line of
the boat is up about 3 to 5 degrees. With the
bow up, the boat may have a greater tenden-
1
cy to steer to one side or the other. Compen-
sate for this as you steer. The trim tab can
also be adjusted to help offset this effect.
When the bow of the boat is down, it is easier
to accelerate from a standing start onto
UP
ZMU05964
DN
UP
DN
ZMU05836
1