Planar VM55MX-M2 User Manual page 53

HDMI CEC

Enable the HDMI CEC functionality.

Note: Only the commands listed in the table below are implemented. Sources that
require other commands may encounter compatibility issues. It is recommended to leave
CEC disabled unless all CEC commands from the source are implemented.
Command
Text View On
Standby
User Control Pressed
Active Source
Give Device Power Status

Options: Off, On

Default: Off
Auto Scan Sources

Select to scan inputs in order until a valid signal is detected. Continue scanning when
the signal on the selected input is lost.

Options: Off, On

Default: Off
Power Down Mode

Select the behavior of the display in standby mode.

Options: Lower Power, Fast Startup

Default: Low Power
Planar VM Series User Manual
020-1357-03A
Supported HDMI CEC Commands
Value
0x0D
0x36
0x44
0x82
0x8F
Operating the Display
Notes
Power key only (Data value 0x40)
Page | 53