Operation; Installing And Removing The Battery Pack - Craftsman CMCW220 Instruction Manual

English
Fig. B
9
3
Dust Collection (Fig. C, D)

WARNING: Collected sanding dust from sanding
surface coatings (polyurethane, linseed oil, etc.)
can selfignite in sander dust bag or elsewhere
and cause fire. To reduce risk, empty bag frequently
and strictly follow sander manual and coating
manufacturer's instructions.
• The dust bag 5 should be emptied after every
10 minutes of sanding.
• To attach the dust bag to the sander, line up the
grooves on the side dust bag collar
10
bag locks 12 on the dust port
• Slide the dust bag 5 onto the dust port and turn the
dust bag clockwise to lock it in place.
• To remove, turn the dust bag
slide off the dust bag.
• To empty the dust bag, remove it from the dust port
and dump the sanding debris into an appropriate trash
receptacle.
Fig. C
5
11
8
with the dust
11
4 .
5 counterclockwise and
10
12
4
Fig. D

OPERATION


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury cause injury.

Installing and Removing the Battery Pack

(Fig. E)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 6
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 7 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. E
6
Proper Hand Position (Fig. F)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
into the tool handle, align the
7