Sony PCG-XG28 Primary User Manual page 104

Ð
Press to select System Time, then set the time (hour: minute: second).
Press Enter to move to the next item.
Î
Press to select Exit, then press
message "Load default configuration now?" appears.
Be sure Yes is selected, and press Enter. If No is selected, press
Yes.
Select Exit (Save Changes), then press Enter. The message "Save
Configuration changes and exit now?" appears.
Be sure Yes is selected, and press Enter. The computer restarts.
Check the floppy disk drive to see if a non-bootable diskette is in the
drive.
If a non-bootable diskette is in the drive, turn off the computer,
remove the diskette, and then turn on the computer again. Confirm
that Windows starts properly. If Windows still does not start, follow
the procedure below to initialize the BIOS.
If the floppy disk drive is empty, follow the steps below to initialize
the BIOS:
Remove any peripheral devices connected to the computer.
Turn off the computer and then turn it on again.
Turn on the computer and press the F2 key when the Sony logo appears.
The BIOS setup menu screen appears.
Press the arrow keys to select the Exit menu.
Press the arrow keys to select "Get Default Values" and then press the
Enter key. The message "Load default configuration now?" appears.
Check that "Yes" is selected, then press the Enter key.
Press the arrow keys to select "Exit" (Save Changes) and then press the
Enter key. The message "Save configuration changes and exit now?"
appears.
Check that "Yes" is selected, then press the Enter key. The computer
restarts.
If your computer still displays the message "Operating system not
found" and Windows does not start, contact Sony Customer Support.
Ð
to select Get Default Values. The
Í
to select