Husqvarna R 214C Operator's Manual page 24

WARNING:
your body, clean with soap and water.
1. Open the plastic cap on the end of the oil drain plug.
2. To make it easier to drain the oil without spill, attach
for example a plastic hose to the end of the oil drain
plug.
3. Put a container below the oil drain plug.
4. Remove the dipstick.
5. Turn the oil drain plug counterclockwise and pull out
to open it.
6. Let the oil run out into the container.
7. Push the oil drain plug in and turn it clockwise to
close it.
8. Remove the plastic hose and put the cap on the oil
drain plug back.
24
If you spill engine oil on
9. Turn the oil filter counterclockwise to remove it.
10. Lightly lubricate the rubber seal on the new oil filter
with new oil.
11. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
12. Fill with new oil as given in
28 .
13. Start the engine and let it idle for 3 minutes.
14. Stop the engine and make sure that the oil filter does
not leak.
15. Fill with oil to compensate for the oil held in the new
oil filter.
Note:
For safe disposal of used engine oil, see
Disposal on page 27 .
To do a check of the transmission oil
level
Note:
Do the transmission oil check when the
transmission is cool.
1. Put the product on a horizontal surface.
2. Remove the screws, one on each side, and remove
the transmission cover.
Technical data on page
1590 - 001 - 11.12.2020