Husqvarna R 214C Operator's Manual page 13

To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The drive system lever is found behind the left rear
wheel.
To lift and lower the cutting deck
To lift the cutting deck to transport position, pull the lift
lever rearward. If the engine is on, the blades stop to
rotate automatically.
To lower the cutting deck to mowing position, press the
lock button and move the lift lever forward. If the engine
is running, the blades start to rotate automatically.
1590 - 001 - 11.12.2020
To start the engine
1. Make sure that the drive system is engaged, see
engage and disengage the drive system on page 13 .
2. Lift up the cutting deck and apply the parking brake.
3. Turn the ignition key to the start position.
4. When the engine starts, immediately release the
ignition key to neutral position.
Note:
Do not run the starter for more than 5
seconds at a time. If the engine does not start, wait
15 seconds before you try again.
5. Turn the key to the lights position to make the
headlights come on.
To
2
1
13