Setting Up The Monitor; Attaching The Stand; Connecting Your Monitor - Dell S2418HN User Manual

Setting Up the Monitor

Attaching the Stand

NOTE: The stand riser and stand base are detached when the monitor is shipped
from the factory.
NOTE: The procedure below is applicable for the default stand. If you purchased
any other stand, see the documentation shipped with the stand to set it up.
CAUTION: Place monitor on a flat, clean, and soft surface to avoid scratching the
display panel.
To attach the monitor stand:
1 Remove the monitor protective cover and place the moitor with its front facing
downward on it.
2 Align the stand bracket with the monitor groove.
3 Insert the stand bracket into monitor groove till it snaps into its place.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section, follow the
Safety Instructions.
To connect your monitor to the computer:
Turn off your computer.
1
2 Connect the VGA (Optional)/HDMI cable from your monitor
to the computer.
3 Switch on your monitor.
4 Select the correct input source at Monitor OSD Menu and turn on your
computer.
Setting Up the Monitor
| 17