Advertisement
The two adjustable clamps can be used in both a vertical and horizontal mode. The long channels in the
table top allow the clamps to be anchored in a stationary horizontal position. The shorter slots in the
table top allow for the clamps to be used in a vertical position (figure J). J1 through J6 illustrate how to
use the clamps in both horizontal and vertical modes.
J1 - To expand the opening of the clamp jaws, press in on the release lever and move the jaw as shown.
The jaw that is attached to the handle can also be moved in the same manner or by squeezing and
releasing the front handle.
J2 - Line up the round post on the end of the clamp bar with the mating openings on both sides of the
main slot in the tabletop as shown.
J3 - To lock the clamp in a horizontal position, squeeze the front handle and line up the round protruding
tabs with the mating openings in the tabletop (behind the openings mentioned in J2 above).
J4 - With the clamp in a fully horizontal position, release the front handle to lock the clamp in place. (To
remove the clamp, squeeze the handle and lift up.)
J5 - Depress the release lever and move the front jaw into position against the material to be clamped.
Squeeze the front handle to apply pressure.
J6 - To clamp vertically, insert the clamp through the slot in the tabletop as shown.
J1
J
Adjustable clamps
J2
Advertisement
