Quick Start Guide
*Images may differ from actual products.
Package Contents
Network Camera
Waterproof Cable
Attachments
Quick Start Guide
Quick
Start
Guide
1
Mount Camera
Wall Mounting
Secure your camera to a wall or an overhead
mounting bracket*.
1. Choose a suitable mounting bracket and fix it with
screws.
2. Secure the camera on the mounting bracket with
screws**.
2
1
*The mounting bracket is not provided and may differ from your
actual product.
**The screws for fixing the camera should be 1/4-20 UNC machine
screws (1/4 means the bolt diameter is 1/4 inch, 20 means that
there are 20 threads per inch on this bolt).
OR
Safety First:
• Make sure your power supply matches your camera.
The camera's standard power supply is 12V DC or
PoE (802.3af/at). The power source should meet
LPS, PS2, and other requirements according to IEC
62368-1.
• Make sure that the wall is strong enough to
withstand 4 times the weight of the camera and
mounting bracket (not provided).
• If you are uncertain or uncomfortable performing the
installation, consult a qualified electrician.
Appearance
Lens
1
Camera
2
*The camera's standard power supply is 12V DC or PoE (802.3af/at).
Installing Waterproof Cable Attachments
Install the waterproof cable attachments for the
network interface when the camera is installed
outdoors.
Note: Make sure each part is securely attached and the
water-proofing rings are flush to keep out water.
Fix Nut Waterproof
Ring
1
1. Route the network cable through the following
components in order: fix nut, waterproof ring,
and then the waterproof jacket.
2. Insert the waterproof ring into the waterproof
2
jacket.
3. Fix the O-ring to the network interface of the
camera and connect the network cables.
4. Attach the network interface with the
waterproof jacket, then twist to lock. Rotate the
fix nut to secure it to the waterproof jacket.
Done! The network interface is now waterproof.
1
2
Power Supply Interface
4
(12V DC)*
Waterproof
Jacket
4
3
O-ring
Network
Interface