Adobe 38040334 - Dreamweaver CS3 User Manual page 218

In the Title box of the Document toolbar, type a name for the frameset document.
2
When a visitor views the frameset in a browser, the title appears in the browser's title bar.
View or set frameset properties
Select a frameset by doing one of the following:
1
•
Click a border between two frames in the frameset in the Document window's Design view.
• Click the border that surrounds a frameset in the Frames panel (Window > Frames).
2 In the Property inspector (Window > Properties), click the expander arrow in the lower-right corner and set the
frameset options.
Determines whether borders should appear around frames when the document is viewed in a browser. To
Borders
display borders, select Yes; to prevent the browser from displaying borders, select No. To allow the browser to
determine how borders are displayed, select Default.
Specifies a width for all the borders in the frameset.
Border Width
Sets a color for the borders. Use the color picker to select a color, or type the hexadecimal value for a
Border Color
color.
Sets frame sizes for rows and columns of the selected frameset, click a tab on the left side or top
RowCol Selection
of the RowCol Selection area; then enter a height or width in the Value text box.
To specify how much space the browser allocates to each frame, select from the following choices in the Units menu:
3
Sets the size of the selected column or row to an absolute value. Choose this option for a frame that should
Pixels
always be the same size, such as a navigation bar. Frames with sizes specified in pixels are allocated space before
frames with sizes specified as percent or relative. The most common approach to frame sizes is to set a left-side frame
to a fixed pixel width and to set a right-size frame to relative, which enables the right frame to stretch to take up all
the remaining space after the pixel width is allocated.
Note: If all of your widths are specified in pixels, and a visitor views the frameset in a browser that's too wide or too
narrow for the width you specified, then the frames stretch or shrink proportionately to fill the available space. The same
applies to heights specified in pixels. Thus, it's generally a good idea to specify at least one width and height as relative.
Specifies that the selected column or row should be a percentage of the total width or height of its frameset.
Percent
Frames with units set to Percent are allocated space after frames with units set to Pixels, but before frames with units
set to Relative.
Specifies that the selected column or row be allocated the rest of the available space after Pixels and Percent
Relative
frames have had space allocated; that remaining space is divided proportionally among the frames with sizes set to
Relative.
September 4, 2007
DREAMWEAVER CS3 211
User Guide