Installation - Johnson Controls S300 Series Hardware Installation

RDR2S-A and I8O4 Hardware Installation
24-10239-596 Rev. D
A
PPLICATION
The RDR2S-A module supports up to two doors per unit. The I8O4 module
supports 8 inputs, 4 relay outputs, and 4 open collector outputs per unit.
Both RDR2S-A and I8O4 use standard S300/RS-485 communications and can
interface with the following controllers:
• CK722
• CK721-A
N : A firmware update to all RDR2S-A and I8O4 modules is recommended
OTE
but optional if no change to the terminal configuration takes place. After
upgrading to CK721-A V3.0 or later, a firmware update to all RDR2S-A and
I8O4 modules is required if changes to the terminal configuration take place.
The RDR2S-A provides the ability to configure supervised 4-state inputs and
unsupervised 2-state inputs. When in physical address mode and used with
CK722 or CK721-A version 3.0 or later, any points not used for the door can be
configured as general purpose input/output (I/O) points, possibly eliminating
the need to purchase additional I/O modules for certain installations.
The RDR2S-A provides power for the card reader hardware. It does not
provide power for door locking hardware.
I
NSTALLATION
Unpacking the Equipment
Carefully inspect the S300-DIN-RDR2SA or S300-DIN-I8O4 shipping
containers as soon as you receive them (with the delivery agent present).
Some shipping companies want to have an agent present when a damaged
container is opened.
If a container is damaged, open it immediately, inspect the contents, and
have the agent make note on the shipping document. Check the purchase
order against the packing slips to ensure the order is complete.
If the contents of a container are damaged in any way, notify the carrier
and your Johnson Controls representative immediately. Report any
discrepancies to your Johnson Controls representative. Save the packing
materials for possible return shipments.
5
Application