Operation - Flymo EasiStore 300R Li Manual

Do not use the FLYMO charger to charge external rechargeable batteries, as
FLYMO cannot guarantee compatibility and could therefore present a risk of fire
or explosion.
Do not charge non-rechargeable batteries.
DANGER! Risk of explosion!
Protect batteries from heat and fire. Do not leave on radiators or expose
to strong sunshine for long periods.
Do not operate them in explosive atmospheres, e. g. in the presence of
flammable liquids (vapours), flammable gases or accumulations of dust.
Batteries may create sparks which could ignite the mixtures.
Check your replacement battery before each use. Visually check the battery
before each use. A non-functioning battery must be disposed of correctly. Do not
send by post. For further details, please contact your local disposal companies.
For risks of injury do not use the battery as a power source for other products.
Only use the battery for the FLYMO product intended.
Only charge and use the battery in ambient temperatures of between 0 °C and
40 °C. Allow battery to cool down after long periods of use.
Check the charging cable regularly for signs of damage or ageing (brittleness).
Only use it in perfect condition.
Do not stow or transport the battery above 45 °C or in direct sunlight. Ideally, the
battery should be stored below 25 °C so that self-discharge is low.
Do not expose the battery to rain, water (immersion) or wet conditions.
Keep battery in order (clean) especially air vents.
If usage of the battery is not planned for a certain time (winter period) reload the
battery to avoid a deep discharge.
Do not store the battery in a product to prevent self-discharge, misuse and acci-
dents.
Do not store the battery in places where static electricity is present.
Electrical safety
DANGER! Cardiac arrest!
This product makes an electromagnetic field while it operates. This
field may under some conditions interfere with active or passive medical
implants. To decrease the risk of conditions that can possibly injure or
kill, we recommend persons with medical implants to speak with their
physician and the medical implant manufacturer before you operate the
product.
Only use the battery product between 0 °C bis 40 °C.
Do not use under wet conditions.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also a risk that the polybag
can suffocate toddlers. Keep toddlers away when you assemble the
product.
Do not use the start levers alternately.
Do not disassemble the product further than the delivery status.
Use gloves, wear slip resistant shoes and wear eye protection.
Do not overload the mower.
Never operate the product when you are tired, ill or under the influence of alcohol,
drugs, or medicine.
Danger of slipping:
– in wet grass
– on steep slopes
– during transport
Be careful while going backwards.
2. ASSEMBLY
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Remove the battery, remove the safety key and use gloves
before you assemble the product.
To assemble the handle [ Fig. A1 / A2 / A3 /A4 ]:
1. Put the springs on the shafts.
2. Put the handle plates on the shafts.
3. Put the lower handle on the shafts.
4. Put the washers on the shafts.
5. Insert the bolts into the quick-release levers.
6. Screw the quick-release levers loosely onto the shafts and clamp
them down.
7. Put the upper handle on the lower handles and slide the screws
through the boreholes (there are 2 holes in the lower handle to choose
the desired height).
8. Put the washers on the screws.
9. Screw the locking nuts onto the screws.
10. Attach the control cable with the cable clips.
To assemble the grass box [ Fig. A5 / A6 / A7 / A8 / A9 ]:
1. Push the grass box handle into the slots in the grass box cover until it
audibly engages.
2. Slide the grass box tongue into the slots in the grass box until it audibly
engages.
3. Align the grass box cover and the grass box locators.
4. Fold the grass box cover towards the grass box.
5. Push the grass box cover on the grass box. Make sure that all clips are
snapped in correctly.
To attach the grass box to the lawnmower [ Fig. A10 ]:
1. Lift the protective cover.
2. Attach the grass box to the hooks on the rear of the mower.

3. OPERATION

DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Wait for the blade to stop, remove the battery, remove the
safety key and use gloves before you adjust or transport the
product.
To charge the batteries [ Fig. O1 ]:
CAUTION!
Overvoltage damages the batteries and the battery
charger.
v Make sure that you use the correct mains voltage.
Before you use the batteries the first time, the batteries must be com-
pletely charged.
The lithium-ion batteries can be charged in any state of charge and the
charging process can be disconnected at any time without to damage
the batteries (no memory effect).
1. Connect the battery charger into a mains socket.
2. Connect the battery charger cable to the batteries.
When the charging control lamp at the charger flashes green
and the 3 green LEDs on the battery light up one after the other,
the battery is being charged.
When the charging control lamp at the charger illuminates
permanently green the battery is completely charged
(Charging time, see 7. TECHNICAL DATA ).
3. Examine the charge status regularly while you charge.
4. When the batteries are completely charged, disconnect the
batteries from the charger.
5. Disconnect the charger from the mains.
Battery charging indicator [ Fig. O2 ]:
v Push the button on the battery.
The battery charging indicator is displayed for 5 seconds.
> 2/3 charged
> 1/3 charged
< 1/3 charged
reserve
To adjust the cutting height:
For the first cut of the season, always cut on the highest cutting height
possible, and gradually lower the cutting height over successive cuts to
your desired height for the lawn.
Only for 300R Li (in 3 positions) [ Fig. O3 / O4 / O5 / O6 / O7]:
The cutting height can be adjusted from 25 – 65 mm.
Position 'Low' (25 mm): Cutting height setting should only be used on
well maintained 'manicured lawns' without excessive moss or thatch.
3 green LEDs illuminate
2 green LEDs illuminate
1 green LED illuminates
1 green LED flashes
5