Viva 7LIECH-SC-SSF User Manual page 10

Dispensing Cold Water
Note: After setup, it will take up to 1 hour to get the water t o its cold temperature. Compressor
will run continuously for 2.5 hours. It will work to build up ice bank, this is normal.
1. Position the bottle, glass, pitcher, or cooking pot securely below the cold water tap.
- The right triangle below the cold water control indicates the location of the cold water tap(See
Parts & Features NO. 6).
- The circular shapes in the drip plate help align the flow of water. This unit dispenses water at a
fast rate. To avoid splashes, hold the cup as close to the tap as possible.
2. Press the cold water control downward to start dispensing water.
3. Release the cold water control once the desired fill level is achieved
Dispensing Hot Water
1. Hot water available 15~20 minutes after set up.
2. Red arrow and target holes in the grill indicate positioning of you container for dispensing hot water.
3. Hold your container close to dispensing nozzle to avoid splashes.
4. To activate hot water dispensing nozzle push red lock inwards and hot button downwards.
5. To stop dispensing hot water release the button.
Replacing an Empty Bottle
Note: Replace the bottle as soon as you notice that it is empty.
1. Lift the bottle straight up to disengage it from the bottle probe.
Excessive Weight Hazard
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
2. Remove the tamper seal from the top of bottle cap of the fresh bottle. Do NOT remove the plastic
cap.
3. Lift the bottle and insert it onto the probe. Apply slight pressure until the plug inside the cap
pushes in and the bottle is seated. Water will begin to flow into the reservoirs, causing air bubbles
in the bottle
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-844-469-8482 for assistance
WARNING
Model # 7LIECH-SC-SSF:Page 10