Table of Contents
Advertisement
PERIODIC MAINTENANCE - Inside the Tank
定期保养 - 皂液箱内部
（续）
5.清洗皂液箱。
Wash the tank.
6.将皂液箱放回原位。
Put the tank back in the original position.
7.安装浮子开关和皂液箱接头。
Mount the float switch and the tank joint.
8.安装罩盖、 环和注液口盖。
Mount the cover, the ring and the cap of
supply port.
9.将支架安装在皂液箱底部。
Mount the bracket from the bottom of the
tank.
每月一次
检查所有管路连接处是否有任何泄漏迹象。
Once a month
Check all tube connections for any signs of leakage.
每年两次
检查所有固定连接处并根据需要拧紧。
Twice a year
Check all fixed connections and tighten as needed.
(Continued)
盖帽螺母
注液口盖
Cap nut
Supply port cap
浮子开关
环
Float switch
Ring
皂液箱接头
Tank joint
支架
罩盖
皂液箱
Bracket
Cover
Tank
18
LONG-TERM NON-USE
长期不使用时
如果长时间不使用皂液器， 请使用以下方法清除皂液器中的所有皂液。
If there will be long periods of time where the dispenser will not be used, remove all soap from
dispenser using the following method.
1.清除皂液箱中的皂液， 并用水清洗皂液箱。
Remove soap from tank and wash tank out with water.
2.将水注入皂液箱中， 按照规定步骤装配皂液器。
Fill the tank with water and set up the dispenser as usual.
3.通过启动皂液器来用水冲洗管路， 直到没有皂液从吐皂口流出。 如果有必要， 请再次注水。
Flush the line with water by activating dispenser until no soap comes out from spout. Refill
water if necessary.
4.倒掉皂液箱中剩余的水， 使皂液箱干燥。
Discard any water left in tank and allow tank to dry.
5.断开电源， 直到恢复使用。
Disconnect the power supply until us e resumes.
故障分析
TROUBLESHOOTING
问题
运行状态
Problem
Operating
皂液液位低
Soap is low
红色LED闪烁
Red LED flashing
感应窗前有遮挡物
Obstruction in front of sensor window
红色LED亮灯
泵工作异常
Red LED lighting-up
Pump is not working correctly
不出皂液
感应窗脏污
-
No soap
Sensor window is dirty
comes out
感应器连接线断开
-
Sensor window is disconnected
电源断开
-
Power supply is disconnected
皂液软管断开
-
Tube is disconnected
持续出皂液
感应窗脏污
-
Soap won't stop
Sensor window is dirty
running
空气管 （蓝色） 断开
-
皂液不成摩斯状
Air tube(blue) is disconnected
It doesn't dispense
皂液粘度高
mousse
-
soap viscosity is high
皂液意外吐出
为防止堵塞， 72小时不使用后， 会自动出皂液。
-
Soap will be automatic dispersed after 72
Soap comes out
unexpectedly
hours of non-usage to prevent clogging.
皂液粘度高
皂液吐出量少
-
Soap viscosity is high
Amount of
dispensed soap
滤网堵塞
-
is small
Filter is clogged
原因
处置方法
Cause
Solution
将皂液注入皂液箱
Fill tank with liquid soap
移开遮挡物
Remove the obstruction
-
清洁感应窗
Clean sensor window
连接感应器连接线
Connect cable
连接电源线
Connect cable
连接皂液软管
Connect tube
清洁感应窗
Clean sensor window
连接空气管
Connect air tube
改用TOTO指定的皂液
Change to TOTO approved liquid soap
-
改用TOTO指定的皂液
Change to TOTO approved liquid soap
清洁滤网
Clean filter
19
Advertisement
Table of Contents
