Basic Operation; Loading Batteries - Bushnell TROPHY CAM 119415 Instruction Manual

•
It is recommended to format the SD-card with the BUSHNELL TROPHY
CAM before using it for the first time.
•
Don't insert or take out the SD-card when the power switch is in the
ON position.
•
The BUSHNELL TROPHY CAM will be in USB mode when connected to a
USB port of a computer. In this case the SD-card functions as a removable
disk, even if the POWER switch is OFF.
•
Turning the power switch to SETUP will force the BUSHNELL TROPHY
CAM into SETUP mode, otherwise, the BUSHNELL TROPHY CAM enters
into the ON mode automatically when switched to the "ON" position.
•
In the setup mode the BUSHNELL TROPHY CAM will shut down
automatically after 3.5 minutes if no key is pressed. Please turn on the
power again if you want to continue to work with the keyboard.
Please be sure that no power interruption occurs during a firmware
upgrade, otherwise the upgrade process could fail. If any fault occurs
after improper upgrading process and the camera stops functioning
properly, please return the device for repair.
If you are not familiar with the operation of the BUSHNELL TROPHY CAM,
the following instructions help you get a quick overview. Before doing
any operation, please make sure you have correctly loaded batteries into
the BUSHNELL TROPHY CAM and plugged the SD-card into the card slot.
If the SD-card is not installed correctly or its write-protect is enabled, the
device will give an alarm with a long beep and then turn off automatically.
The following gives you detailed instructions for operating the TROPHY
CAM.

3.1 Loading Batteries

First, you will need to load the TROPHY CAM with batteries. In fact, there
are two methods to supply power for the device: one is to use eight
AA batteries and the other is to use an external DC power supply. It is
recommended to use eight new alkaline or lithium AA batteries. Internally
the batteries are divided into two paralleled groups; each group contains
6
2 Cautions

3 Basic Operation

(continued)