Advertisement
3. Fasten the LF seat belt.
4. With a scan tool, observe the seat belt buckled
parameter in the instrument panel cluster (IPC) data
3
list.
Does the scan tool indicate that the seat belt is buckled?
1. Disconnect the LF seat belt switch connector.
2. With a scan tool, observe the seat belt buckled
parameter in the instrument panel cluster (IPC) data
4
list.
Does the seat belt parameter change state?
Replace the LF seat belt switch. Refer to Seat Belt Buckle
5
Replacement - Front .
Did you complete the replacement?
Test the signal circuit of the seat belt switch for a short to
ground. Refer to Circuit Testing and Wiring Repairs in
6
Wiring Systems.
Did you find and correct the condition?
Replace the inflatable restraint sensing and diagnostic module
(SDM). Refer to Inflatable Restraint Sensing and
7
Diagnostic Module Replacement
Did you complete the replacement?
Replace the IPC. Refer to Instrument Panel Cluster (IPC)
8
Replacement in Instrument Panel, Gauges and Console.
Did you complete the replacement?
Operate the system in order to verify the repair.
9
Did you correct the condition?
FASTEN SAFETY BELT INDICATOR/CHIME INOPERATIVE
Fasten Safety Belt Indicator/Chime Inoperative
Step
Schematic Reference:Seat Belt Schematics
Connector End View Reference:Seat Belt Connector End Views
Did you review the Diagnostic Starting Point - Seat
1
Belts?
Did you perform the Diagnostic System Check -
2
Instrument Cluster ?
1. Turn ON the ignition, with the engine OFF.
2. Observe the seat belt indicator illumination during
Action
Go to
Step 8
Go to Step 4
Go to
Step 5
Go to Step 6
Go to
Step 9
Go to
Step 9
Go to Step 7
Go to
Step 9
Go to
Step 9
System
OK
Go to Step 2
Yes
Go to Diagnostic
Starting Point - Seat
Go to Step 2
Go to Diagnostic
System Check -
Go to Step 3
Instrument Cluster
-
-
-
No
Belts
Advertisement
