Electrical Connection To The Burner Box Using Line Voltage Thermostat On Control; For External Thermostat Connection; Electrical Connection To Burner Box With Optional External Low Voltage Thermostat - Roberts Gorden COMPLETE HED Series Installation, Operation & Service Manual

10.4 Electrical Connection to the Burner Box Using Line Voltage Thermostat on Control

Connect wires together with
suitable approved wire connections.
L2
Gnd.

10.5 For External Thermostat Connection

Run two wires from low voltage thermostat through
conduit as shown. The blue wire from the R1 relay
and the blue wire from the transformer have 1/4" (6
mm) blade female electrical terminals, which are con-
nected by a black jumper wire. Cut the female

10.6 Electrical Connection to Burner Box with Optional External Low Voltage Thermostat

Green to Gnd.
L1
White to L2
Black to L1
Conduit Hole
Liquid Tight Conduit
Connector
(Supplied by Others)
White
Green
Black
connections off the ends of the 2 blue wires and strip
the ends approximately 1/2" (1.3 cm). Connect these
2 wires to the thermostat wires using suitable wire
connectors.
SECTION 10: W
IRING
Internal Wire Bundle
Burner Box
Liquid Tight Flexible
Conduit for Outdoor
Use or Equivilent
49