Pnp/Pci Configurations - Acer Veriton 7600G Service Manual

PnP/PCI Configurations

The table below describes each PnP/PCI configuration parameter. Settings in boldface are the default and
suggested settings.
Parameter
Reset Configuration Data
Resources Controlled By
IRQ Resources
IRQ 3 (COM2)
IRQ 4 (COM1)
IRQ 5 (Network/Sound or
Others)
IRQ 7 (Printer or Others)
IRQ 9 (Video or Others)
IRQ 10 (SCSI or Others)
IRQ 11 (SCSI or Others)
IRQ 12 (PS/2 Mouse)
IRQ 14 (IDE1)
IRQ15 (IDE2)
49
Description
Select Enabled to reset Extended System
Configuration Data (ESCD) when you exit Setup
if you have installed a new add-on and the
system configuration has caused such a serious
conflict that the OS cannot boot.
Setting this option to Manual allows you to
individually assign the IRQs and DMAs to the
ISA and PCI devices. Set this to Auto to enable
the auto-configuration function.
Set " Resources Controlled By" to Manual to
show the IRQ Resources.
If your ISA card is not PnP compatible and
requires a special IRQ to support its function, set
the selected IRQ to Legacy ISA. This setting
informs the PnP BIOS to reserve the selected
IRQ for the installed legacy ISA card. The default
is PCI/ISA PnP. Take note that PCI cards are
always PnP compatible (except old PCI IDE
cards).
Options
Disabled
Enabled
Auto (ESCD)
Manual
PCI/ISA PnP
Legacy ISA
Veriton 3600(D/G)/5600(D/G)/7600(D/G)