Important Safety Instructions; Important Warnings - Tripp Lite PDUMV30-ISO Owner's Manual

Important Safety Instructions

SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be
followed during the installation, operation and storage of this
product. Failure to heed these instructions and warnings will
void the product warranty.
CAUTION
Only those who are properly trained or qualified to use this device
should do so. Anyone who is not trained or qualified should not use this device
unless it is under the supervision of someone who is properly trained or qualified
to do so. Children must be supervised to ensure that they do not use the device
as a toy.
Never use the device if the cord and plug are damaged; if it is not working
properly, or if it has been dropped or damaged, take it to an authorized service
center for inspection and repair.
If the power cord is damaged, it must be replaced by the manufacturer, its
authorized service agent, or by qualified personnel in order to avoid a danger.

Important Warnings

• The PDUMV30-ISO PDU model provides surge and line noise protection to connected
equipment through its outlets.
• Non-ISO PDUs do not provide surge and line protection to connected equipment.
• The PDU is designed for indoor use only in a controlled environment away from excess
moisture, temperature extremes, conductive contaminants, dust or direct sunlight.
• The PDU must be installed by a qualified technician only.
• Install in accordance with National Electrical Code standards. Be sure to use the proper
overcurrent protection for the installation, in accordance with the plug/equipment rating.
• Connect the PDU to an outlet that is in accordance with your local building codes and
adequately protected against excess currents, short circuits, and earth faults.
• Keep indoor ambient temperatures between 32°F and 77°F (0°C and 25°C).
• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to
significantly affect its safety or effectiveness is not recommended. Do not use this
equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous
oxide.
• Do not connect the PDU to an ungrounded outlet or extension cords or adapters that
eliminate the connection to ground.
• The power requirement for each piece of equipment connected to the PDU must not
exceed the individual outlet's load rating.
• The plug on the power supply cord serves as the disconnect device.
• The electrical outlets that supply power to the equipment should be near the equipment
and easily accessible.
• The total power requirement for equipment connected to the PDU must not exceed the
maximum load rating for the PDU.
2