Hardware Description
The access point has these connections on the bottom panel of the device.
Bottom Panel Connections
Reset Button
Resets the access point to factory-default settings.
Use a paper clip or other small object to press the reset button through the hole.
Press and hold the reset button for up to 10 seconds. When you release the reset button, all
LEDs will go off to indicate that the device has rebooted.
USB Port
This port is currently not in use.
Serial Console
RJ-45 port is for serial console connections to the access point.
LAN (POE+)
This is a LAN port that connects the access point to a wired LAN connection through a switch or
hub. This port also provides PoE+ (802.3at) power for the device.
DC 12V
If PoE power is unavailable, you can power the device with the optional 12V DC power adapter
(WG9009).