Acer Aspire T320 Service Manual page 42

Parameter
Power On by Ring
USB KB Wake-Up From S3
Resume by Alarm
Reload Global Timer Events
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
FDD,COM,LPT Port
PCI PIRQ [A-D]#
PWRON After PWR-Fail
Chapter 2
Description
An input signal on the serial Ring Indicator (RI)
line (in other words, an incoming call on the
modem) awakens the system from a soft off
state.
This option allows you to specify whether the
system will be awakened from power saving
modes when activity or input signal of the
specified hardware peripheral or component is
detected.
When set to Enabled, the following three fields
become available: Month Alarm, Day of Month
Alarm, and Time Alarm Upon arrival of the alarm
time, it will instruct the system to wake up.
When this item is enabled, the system power will
resume the system from a power saving mode if
there is any activity on primary or secondary IDE
channels 0 or 1.
When this item is enabled, the system will restart
the power-saving time-out counters when any
activity is detected on the floppy disk drive, serial
ports, or the parallel port.
When this item is enabled, any activity from one
of the listed devices wakes up the system.
This item specifies when your system reboot
after a power failure or interrupt occurs.
Options
Enabled
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
Disabled
Off
On
Former-Sts
35