Operating Fireplace - Superior VRL4543ZEN Installation And Operation Instructions Manual

FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which au-
tomatically lights the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Do not use this appliance if any part has been under water. Imme-
diately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been under water.
INSTRUCTIONS
NOTICE: During initial operation of new heater,paint
will give off a paper-burning smell. Orange flame will
also be present. Open damper or window to vent
smell. This will only last a few hours.
This appliance requires 120V electricity for normal operation. Control
module should be plugged into electrical outlet located underneath
firebox bottom. Back up battery supply is available for power outages.
1. STOP! Read the safety information, column 1.
2. Make sure equipment shutoff valve is fully open.
3. Turn safety shutoff switch to the OFF position.
4. Remove access cover.
5. Turn equipment shutoff valve clockwise to the OFF position (see
Figure 30). Do not force.
Incoming
Gas Line
126861-01L

OPERATING FIREPLACE

LIGHTING
Equipment Shutoff Valve
Figure 30 - Turning Equipment Shutoff Valve to the OFF Position
SuperiorFireplaces.us.com
1. Wait five (5) minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow "B" in
the safety information. If you don't smell gas, go to the next step.
2. Turn equipment shutoff valve counterclockwise to the ON posi-
tion. Do not force.
3. Replace access cover.
4. Turn on all electric power to appliance.
5. Turn safety shutoff switch to the ON position.
6. Visually locate pilot. Igniter should begin to spark and main
burner should ignite once flame appears at pilot.
• If lighting appliance for the first time each season, it may
take several attempts before supply gas can reach pilot
and main burners.
• If appliance will not stay lit after several attempts, follow
instructions under To Turn Off Gas To Appliance and call
your service technician or gas supplier.
CAUTION: Do not try to adjust heating levels by
using the equipment shutoff valve.
TO TURN OFF GAS
TO APPLIANCE
1. Turn off safety shutoff switch.
2. Turn off all electric power to appliance if service is to be performed.
3. Remove center brick/control cover.
4. Turn equipment shutoff valve clockwise to OFF. Do not force.
5. Replace access cover.
19