Advertisement
Diagnostics:
Diagnostic mode is automatic and will be displayed by flashing the parking lights a
number of times representative of the failed start, or premature shut down based on the
chart below. When a failure occurs, or a shut down occurs which in out of the ordinary
the parking lights will flash 1 thru 8 times immediately after to advise what the failure
could have been.
1 Flash
Run timer expired
2 Flashes
Low or no tach signal (RPM)
3 Flashes
Positive inhibit wire activation
4 Flashes
Manual Transmission Mode Error
5 Flashes
RF shutdown signal received, or manual start trigger wire reactivated.
6 Flashes
High tach signal (RPM)
7 Flashes
Tach signal has not been learned
8 Flashes
Negative inhibit wire activation
4 PIN DATA BUS PORT (DBI Port)
The 4 pin port located on the side of this module is for proprietary Flash-Logic data bus
interface modules. These modules are used to access a variety of features in the vehicle
which can be as simple as door trigger inputs, to more complex door lock outputs, or
transponder interfaces for remote starting. DO NOT connect anything to this port other
than the appropriate Data Bus Interface modules or damage to the Remote Start Could
occur. All installation instructions for the Data Bus modules will be packaged with the
individual component along with the proper 4 pin wiring harness requires to access the
data transmit & receive as well as the proper voltage levels for the interface.
COMPLETING THE INSTALLATION:
After you have confirmed the operation of the Remote Start unit and tested all the safety
features of the system:
1. Mount the control module up and behind the dash securing it in place with cable
ties or screws. Be certain that the chosen mounting location will not inhibit any of
the controls of the vehicle.
2. Securely harness and tie all wiring up and away from all hot and moving parts that they
may come in contact with under the dash board or in the engine compartment areas.
CAUTION: Particularly avoid the area around the steering shaft and column, as wires
can wrap around these mechanisms and impair the safe operation of the
vehicle.
3. Apply the Caution Labels supplied with this kit to a conspicuous area in the engine
compartment. Make sure to clean the surface before affixing the label.
4. Check the vehicle's wipers, lights, horn, etc, to insure proper operation.
5. Replace all panels that were removed during installation, and retest the system.
6. Explain all activated features and safety systems associated with Remote Start Unit
installed to the customer.
Page 14
128-9482
14 of 16
Advertisement
