Table of Contents
Advertisement
Miscellaneous Tools
Using Boot Sequence Selector
The Boot Sequence Selector allows the boot order to be changed without accessing the BIOS
Setup Utility. To use the Boot Sequence Selector, perform the following:
1. At a DOS prompt, enter bs <#> and a boot sequence ID number. A boot sequence ID is a
digit from 1 to 4. (Figure 2-31)
D:\BOOTSEQd>bs
*** Boot Sequence Selector Version 0.03 ***
Created by Rockwell Chuang 10/01/2005.1.
Usage:
BS [ 1 | 2 | 3 | 4 ]
BS 1: [Floppy] => [HardDisk] => [CD-ROM] => [LAN]
BS 2: [HardDisk] => [CD-ROM] => [LAN] => [Floppy]
BS 3: [CD-ROM] => [HardDisk] => [LAN] => [Floppy]
BS 4: [LAN] => [Floppy] => [HardDisk] => [CD-ROM]
D:\BOOTSEQ>
Figure 2-31. Boot Sequence Selector
Example: bs <2>, selects the boot sequence of HDD | CD ROM | LAN | Floppy.
System Utilities
0
0
2-25
Advertisement
Table of Contents
