Acer Aspire 5515 Service Manual page 36

Parameter
PS/2 Mouse
IDE Controller
On Chip SATA
SATA Mode
SATA Smbus
Interface
USB Host
Controller
Legacy USB
Support
Option ROM
Placement
Gigabit Lan
Network Boot
Large Disk Access
Mode
Installed O/S
Reset
Configuration Data
Processor
Assisted
Virtualization
Chapter 2
Description
Enable or Disable PS/2 Mouse port IRQ12.
Configure the Integrated Local Bus IDE
Controller.
Enable On chip SATA.
Select the SATA Mode.
Enable or disable the SATA Smbus
Interface.
Enable or disable USB hardware.
Enable support for Legacy Universal Serial
Bus.
Determines which peripheral devices can
be booted.
NOTE: Changes to this setting can cause
the system to halt during boot.
Enable or disable the on board Gigabit
LAN.
Enable to support LAN on mainboard boot
or disable for faster stand alone boot.
Set the Large Disk Access mode. Different
O/S require different drive geometry
representations. Select Other for UNIX,
Novell NetWare, or other O/S.
Set the most commonly used O/S on the
system.
Clear Extended System Configuration Data
(ESCD) area.
Enable the hardware visualization support.
Submenu Items
Option: Enabled, Auto Detect, or
Disabled
Option: Disabled or Enabled
Option: Enabled or Disabled
Option: IDE-ACHI or IDE Native
Option: Enabled or Disabled
Option: Enabled or Disabled
Option: Enabled or Disabled
Option: Disabled, Temporary, or
E000 Extend
Option: Enabled or Disabled
Option: Enabled or Disabled
Option: DOS or Other
Option: Other, Win2000, WinMe,
Win98, or Win95
Option: No or Yes
Option: Enabled or Disabled
25