Accessory List; Installation; Caution Concerning The Installation Location; Mounting The Microphone - Alpine iLX-W650E Owner's Manual

Accessory List

Main unit............................................................................................................. 1
Power cable........................................................................................................ 1
USB extension cable ....................................................................................... 1
PRE OUT cable................................................................................................... 1
Microphone ....................................................................................................... 1
Owner's Manual ......................................................................................... 1set

Installation

Caution
• Do not block the unit's fan, thus preventing air
circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
Heat sink
Rear of the Unit

Caution concerning the installation location

Angle of installation
Install at an angle between horizontal and 30°. Note that installing at
an angle outside of this range will result in a loss of performance and
possibly damage.

Mounting the Microphone

For safe use, make sure of the following:
• Location is stable and firm.
• Does not interfere with safety equipment.
• Driver's view and operations are not obstructed.
• Microphone is located where the driver's voice can be easily
picked up (for example, on the sun visor).
When you speak into the microphone, you should not have to change
your driving posture. This may cause a distraction, taking your
attention away from safely driving your vehicle. Carefully consider
direction and distance while mounting the microphone. Confirm that
the driver's voice can be easily picked up at the selected location.
42
-EN
Cable clamp
(sold separately)
Installation example using the Original
Mounting Bracket
1
Mount the original mounting bracket to the unit using
the supplied screws.
Original Mounting Bracket
Ground Lead*
2
Connect all other leads of the unit according to details
described in the "Connections" (page 43).
3
Mount the unit in a car.
0 - 30°
* To securely connect the ground lead, use an already installed screw on a
metal part of the vehicle (marked (
vehicle's chassis.
• Fix the cables carefully. Do not damage them by mounting them into
movable parts, such as the seat rail, or by locating them against sharp or
pointed edges.
4
Reattach the removed vehicle parts (panels, etc.) or
other aftermarket dash kit back onto the vehicle.
Microphone
Screws (M5×8)
(included)
Chassis
)) or a clean, bare metal spot on the