Clean Fuel Filter; Engine Oil Replacement - Echo IG3500E Operation Manual

ClEAN FUEl FIlTER

ENGINE OIl REPlACEMENT

maintenance
1. Unscrew the screw (1) and take off the left
exterior cover (2).
2. Drain the fuel in the fuel tank. Hold the
tube clip (3) toward downward and pull
out the fuel tube (4) which is connected
onto the fuel tank, then disassemble fuel
filter.
3. Put the fuel filter (5) into noncombustible
or higher flash point solvent and clean it.
4. Assemble fuel filter to the main jet (6) on
the fuel tank then install tube clip.
Avoid draining the engine oil immediately after
stopping the engine. The oil is hot and should
be handled with care to avoid burns.
1. Place the generator on a level surface and
warm up the engine for several minutes.
2. Unscrew the screw (1) and take off the
sight glass of engine oil (2).
3. Lift and tilt the machine; take off the end
cap (3) at the bottom plate of machine
4. Remove the oil filler cap.
5. Place an oil pan under the engine, remove
the oil drain bolt (6) drain the oil from the
oil tank.
6. Check oil filler cap (4), O-ring (5), Oil drain
bolt (6), Oil filler cap packing (7). Replace
immediately with new components if any
are damaged.
7. Assemble oil drain bolt and oil filler cap
packing.
8. Add oil to a suitable level, tighten oil filler
cap.
9. Assembly the end cap at the bottom of
machine .
10. Assembly the sight glass of engine oil.
27