Alternating Current (Ac) Connection - Echo IG3500E Operation Manual

AlTERNATING CURRENT (AC) CONNECTION

• Be sure any electric devices are turned off before plugging them in.
• Be sure all electric devices including the lines and plug connections
are in good condition before connection to the generator.
• Be sure the total load is within generator rated output.
• Be sure the receptacle load current is within receptacle rated current.
TIP: Make sure to ground (Earth) the generator. When the electric device
is earthed, always the generator must be earthed.
1. Start the engine.
2. Turn the ESC to "ON".
3. Plug in to AC receptacle.
4. Make sure the AC pilot light is on.
5. Turn on any electric devices.
TIP: The ESC must be turned to "OFF" before increasing engine speed
to rated rpm.
• Most motorized appliances require more than their electrical rating for
startup. When an electrical motor is started, the overload indicator (red)
may come on. This is normal if the overload indicator (red) goes off
within 4 seconds. If the overload indicator (red) stays on, consult your
generator dealer.
• If the generator is connected to multiple loads or electricity consumers,
please remember to first connect the one with the highest starting
current. And last connect the one with the lowest starting current.
18
operation
TIP: Turn off any electric devices.
1. Disconnect any electric devices.
2. Turn the ESC to "OFF" (1).
3. Turn the 3 in 1 switch to "OFF" (2).
a. Ignition circuit is switched off.
b. Fuel valve is switched off.
WARNING
NOTICE