Operation; Cleaning The Filter - Hoover H84-7WD-ZA Instructions And Warranty

Important!
• When the charging process is complete, this may take 5 to 6 hours for completely
discharged batteries, the device will switch over to a trickle charge (maintenance
function) automatically. Nevertheless, to avoid possible damage to the batteries, do
not leave the appliance permanently connected to the power adapter (4).
• Reconnect the appliance with the power adapter (4) when the suction power has
become noticeably weaker.
Note:
The hand vacuum cleaner can also be charged directly via the power adapter (4). To
do this, remove the power cord 5 with a slight twist from the wall mount (3) and insert
it into the socket on the hand vacuum cleaner.

OPERATION

Warning!
The suction opening must always be open and free of any dirt of debris. Blockages
may lead to overheating and damage to the motor.
When in use, the LED indicator light (7), glows GREEN. When power is Low, it glows
Blinking GREEN. When running low on power, it will blink fast for 3 seconds and
power off. Check to ensure that the on/off switch (6) is slid back to the position "0"
when this has occurred.
Tips:
• Ensure that the dust filter (9), is always inserted before using the appliance.
• Vacuum only as much liquid as will fill the dirt container (0), to the MAX mark.
Always use the appropriate nozzle for the task at hand:
• the crevice nozzle (2), to clean narrow and difficult to reach locations.
• the wet vacuum nozzle (1), for vacuuming liquids.
Note:
After you have vacuumed up liquids, immediately clean the dirt container (0),
otherwise bacteria and microbes could form in it. Ensure that the dust filter (9), is
completely dry before using the appliance again.
3. To switch the appliance on, slide the on/off switch (6), forwards.
4. After using the product, slide the on/ off switch (6), to the rear off position.

CLEANING THE FILTER

To achieve the best results, empty the dirt container (0), and clean the dust filter 9
after every use.
Important!
Do not use aggressive, chemical or abrasive cleaning agents, as these could
damage the surfaces of the appliance.
1. To open the dirt container (0), press the unlock button (8), and remove the dirt
container (0).
2. Remove the dust filter (9) from the dirt container (0).
Empty the dirt container (0).
Pull the dust filter bag by its mounting out of the dust filter (9).
Rinse the dust filter bag in cold water and then wait until it is completely dry before