Config2 Menu - ViewSonic VS16854 User Manual

Playlist: select playlist index for Media player,
Browser, PDF player.
0: no play list. Same as switch source from
OSD.1~7: playlist number.
WOL
Choose to turn on or off the wake on LAN function.
Choose from : {Off} / {On}
NOTE
:
• WoL is not supported when power save mode
set as Mode 3 and Mode4.
• System only turn of backlight when DC off in
Mode 3 and Mode 4.
• If user want to power on system in Mode 3 and
Mode 4, user can use power on command of
RS232 over LAN.
Power LED light
Choose to set power indicate LED on or off.
Choose {On} for normal use.
Network
Launch Network setup and the input source will be
changed to Custom for Android network setting.
When exit the network setting, input source will be
back to the latest input source.
LED Indicator
LED Status Power Status
LED Active Normal ON
Sleeping
RC command
Schedule on
Standby/DC power off
LED Not-active Switch off
Configuration1 reset
Reset all settings in Configuration1 menu to the
factory preset values.
Factory reset
Reset all settings in the OSD menus of {Picture},
{Screen}, {Audio}, {PIP}, {Configuration 1},
{Configuration 2}, and {Advanced option} to the
factory preset values.
Android settings will also reset when factory reset.
LED behavior
Green
Ambera
RED blinking+GREEN
RED+GREEN
blinking(DC Off)
If ON TIME is "--:--", the
LED is not blinking.
RED
Blank
25

5.1.6. Config2 menu

Configuration 2
OSD turn off
Advanced option OSD H-position
OSD V-position
OSD transparency
Information OSD
Logo
Monitor ID
Heat status
Monitor information
DP version
OSD turn off
Set the period of time the OSD (on-screen display)
menu stays on the screen.
The options are: {0 ~ 120} seconds.
NOTE: {0} does not disappear automatically.
OSD H-position
Adjust the horizontal position of the OSD menu.
OSD V-position
Adjust the vertical position of the OSD menu.
OSD Transparency
Adjust OSD transparency.
• {Off} - Transparency off.
• {1-100} - Transparency level 1-100
Information OSD
Set the period of time the information OSD is
displayed on the upper right corner of the screen.
The information OSD will display when input signal
is changed.
The information OSD will remain on the screen
with {Off} selection.
The options are: {1 ~ 60} seconds.
Logo
Choose to enable or disable the picture of Logo
when turn on your display.
NOTE: Logo will NOT rotate with rotation setting/
detection.
Monitor ID
Set the ID number for controlling the display via
the RS232C connection.
Each display must have a unique ID number when
multiple sets of this display are connected. Monitor
ID number range is between 1 to 98.
Heat status
This function allows you to check the thermal
status and fan speed of the display at any time.
45
50
50
Off
10 Sec
On
1
Action
Action
DP 1.1