4.8.1 Link Aggregation Settings
This page allows configuring Link Aggregation Settings. The Link Aggregation Settings screens in
The page includes the following fields:
Object
System Priority
Link Aggregation
Algorithm
Member
Status
Type
Figure 4-8-2 LAG Setting Page Screenshot
Description
The Priority controls the priority of the port.
If the LACP partner wants to form a larger group than is supported by this device
then this parameter will control which ports will be active and which ports will be
in a backup role. Valid values are in the range
Lower number means greater priority.
Select load balance algorithm mode:
MAC Address Source: The MAC Address Source can be used to calculate the
port for the frame.
MAC Address Source & Destination: The MAC Address Source & Destination
can be used to calculate the port for the frame.
Select port number for this drop down list to esatablish Link Aggregation.
Indicates the LAG status operation. Possible statuses are:
Enabled - Start up the LAG manually.
Disabled - Shutdown the LAG manually.
Indicates the trunk type.
74
User's Manual of FGSW-1816HPS
Figure 4-8-2
appears.
1 ~
65535.