Taillamps, Turn Signal, Stoplamps And Back-Up Lamps - Pontiac 2003 Montana Owner's Manual

7. To reinstall the lamp assembly, line up and insert
the tabs on the back of the assembly in the slots in
the fender. Engage the lower clip on the back of
the lamp assembly into the fender, keeping
the upper tab on the front turn signal/parking lamp
assemblv inboard of the headlamp bracket tab.
8. To align the front turn signaVparking lamp assembly
with the headlamp assembly, lift up the front turn
signaVparking lamp assembly until the upper edge is
contacting the fender.
9. Faster; the front turn signal/parking lamp asserilbly
to the headlamp assembly with the thumbscrew
removed in Step 2.
Taillamps, Turn Signal, Stoplamps
and Back-up Lamps
1. Open the liftgate.
2. Remove the two screws from the taillamp housing
3. Pull off the entire taillamp housing.
on the inboard side.
The locator/retaining pins on the outboard side are
part of the lamp assembly and will remain intact
during removal.
4. Remove the buib hoides by pressing the four
retaining tabs and pulling the holder away from the
assembly.
5-55