Pontiac 2003 Montana Owner's Manual page 126

Resetting the Power Sliding Door
The power sliding door may operate incorrectly or not at
all because of the following conditions:
A low voltage or dead battery,
disconnecting the battery, or
if the instrument panel PWWHEATED SEAT PSD
fuse or the underhood fuse 8, 27 or 29 are
removed or blown.
See Fuses and
Circuit
Breakers on page 5-95 for more
information about your fuse panel.
If any of these conditions occur, the power sliding door
will need to be reset. If your vehicle has the dual
power sliding doors, both doors will have to be reset. To
do this:
1. Check to be sure the power sliding door is unlocked
2. Turn the ignition key to OFF.
and securely closed.
3. i f
w , . l ,
iui.i.l
ijuwei- s;iLlii-ly dlOi- o.".ei-i?ide
S.vv/tC;-,
o.m
4. Remove fuse 29 from the underhood fuse block.
Leave it out for 30 seconds.
5. Reinstall the fuse and wait 10 seconds.
6. Turn the power sliding door override switch on.
7. Press either of the power door lock switches to open
the power sliding door.
8. Open the door all of the way.
9. Wait five seconds and close the door by pressing
either power door lock switch.
10. Wait five seconds and repeat Steps 7 through 9.
If the door does not rest in the fully open position after
repeating Step 7, repeat Steps 7 through 9 again. If
the door still does not operate correctly, see your dealer
for service.
2-1 9