Installing The Vent Kit Of Dryer - LG WK2 S6 Series Owner's Manual

INSTALLATION
22
9
Reinstall the terminal block access cover.
a Hot lead (black and red)
Neutral wire (white)
b
External ground wire (if required by local
c
codes)
Wire from the appliance harness
d
Ground screw (green)
e
Installing the Vent Kit of
Dryer
The appliance is configured to vent to the rear. It
can also vent to the side.
WARNING
• Use long-sleeved gloves and safety glasses.
• Use a heavy metal vent.
• Do not use plastic or thin foil ducts.
• Clean old ducts before installing the appliance.
NOTE
• An adapter kit, part number 383EEL9001B, may
be purchased from your LG retailer. This kit
contains duct components necessary to change
the appliance vent location.
• Right-side venting is not available on gas
models.
• Bottom venting is not available on stacked or
integrated stacked models.
Side Venting
1
Remove the rear exhust duct retaining screw
and pull out the exhaust duct
a
b
2
Press the tabs on the knockout
remove the knockout for the desired vent
opening. (Right-side venting is not available on
gas models.) Press the adapter duct
blower housing and secure to the base of the
dryer as shown.
d
3
Preassemble a 10 cm elbow
cm duct section, and secure all joints with duct
tape. Be sure that the male end of the elbow
faces AWAY from the dryer. Insert the elbow/
duct assembly through the side opening and
press it onto the adapter duct. Secure it in place
with duct tape. Be sure that the male end of the
duct protrudes 3.8 cm to connect the
remaining ductwork. Attach the cover plate
to the back of the dryer with the included
screw.
f
e
.
b
a
and carefully
c
onto the
d
c
to the next 10
e
f