Before Using For The First Time; Preparing The Appliance; Basic Operation; Cable Length - Bosch MUM5X GB Series User Manual

Start lock-out
Start lock-out prevents your appli-
ance from being switched on acci-
dentally.
The appliance can only be switched
on and operated if
¡ the swivel arm is engaged in posi-
tion 1 and the bowl or an access-
ory is inserted, e.g. Ice maker.
¡ the swivel arm is engaged in posi-
tion 3 and the protective cover or
an accessory is fitted on drive 3.
Restart lock-out
Restart lock-out prevents your appli-
ance from automatically restarting
processing after a power failure.
The appliance is switched on again
after a power failure. Processing can-
not start again until the rotary switch
has been set to
Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.
The motor will switch off if
¡ too large a quantity is processed.
¡ a tool or accessory is blocked.

Before using for the first time

6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Preparing the appliance
Press the release button and raise
1.
the swivel arm until it engages.
→ "Moving the swivel arm",
Page 17
Turn the bowl clockwise and re-
2.
move.
→ "Removing bowl", Page 18
⁠ .
Before using for the first time en
Clean all parts that come into con-
3.
tact with food before using for the
first time.
→ "Cleaning and servicing",
Page 21
Put the cleaned and dried parts
4.
out ready for use.

Basic operation

7 Basic operation
Basic operation
7.1 Cable length
Adjust the length of the power cable
to your needs.
Adjusting cable length via cable
rewinder
Pull the power cable out to the re-
1.
quired length and slowly let go.
To shorten the cable,
2.
pull the cable,
‒
allow the cable to wind up,
‒
pull the cable out again.
‒
Note: Do not push the cable in by
hand. If the cable jams, pull right out
and let it wind up again.
7.2 Moving the swivel arm
Press the release button and raise
1.
the swivel arm until it engages.
→ Fig.
6
a The swivel arm is fixed in posi-
tion 2.
Press the release button and move
2.
the swivel arm down until it en-
gages in the vertical position.
→ Fig.
7
a The swivel arm is fixed in posi-
tion 3.
17