Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.
The motor will switch off if
¡ too large a quantity is processed.
¡ a tool or accessory is blocked.
Before using for the first time
Before using for the
first time
Prepare the appliance for use.
Before using for the first time
Preparing the appliance
Press the release button and raise
1.
the swivel arm until it engages.
→ "Moving the swivel arm",
Page 17
Turn the bowl clockwise and re-
2.
move.
→ "Removing bowl", Page 17
Clean all parts that come into con-
3.
tact with food before using for the
first time.
→ "Cleaning and servicing",
Page 21
Put the cleaned and dried parts
4.
out ready for use.
Basic operation
Basic operation
Basic operation
Cable length
Adjust the length of the power cable
to your needs.
Adjusting cable length via cable
rewinder
Pull the power cable out to the re-
1.
quired length and slowly let go.
To shorten the cable,
2.
Before using for the first time en
pull the cable,
‒
allow the cable to wind up,
‒
pull the cable out again.
‒
Note: Do not push the cable in by
hand. If the cable jams, pull right out
and let it wind up again.
Moving the swivel arm
Press the release button and raise
1.
the swivel arm until it engages.
→ Fig.
6
a The swivel arm is fixed in posi-
tion 2.
Press the release button and move
2.
the swivel arm down until it en-
gages in the vertical position.
→ Fig.
7
a The swivel arm is fixed in posi-
tion 3.
Inserting bowl
Place the bowl in the base unit.
1.
→ Fig.
8
Use the recesses on the base unit.
Turn the bowl anticlockwise until it
2.
engages.
→ Fig.
9
Removing bowl
Turn the bowl clockwise and re-
▶
move.
→ Fig.
10
Inserting tools
Select the tool required.
1.
→ "Overview of tools", Page 15
Press the tool into the main drive
2.
until it engages.
→ Fig.
11
17