Siemens SINUMERIK ONE NCU 1740 Equipment Manual page 141

Digital inputs
• Characteristics:
– X222: DI 3.0 to 3.7 are connected as rapid inputs.
– The inputs have no signaling (status LEDs).
– The inputs are not isolated.
– It is not possible to connect 2-wire BEROs.
• Terminal assignment for the digital inputs:
The following figure shows an example of the terminal assignment for the digital inputs on
connector X111. Connectors X222 and X333 are assigned analogously.
Figure 12-15
• Power supply for digital inputs (X111, X222, X333: Pin 2)
– The internal power supply (P24OUT) is taken from the general power supply of module
– Alternatively, an external power supply can be connected if the load at the digital outputs
• Technical data:
Table 12-45
Digital inputs
High-level voltage (U
Input current I
NCU 1740
Equipment Manual, 10/2021, A5E51087503B AA
①
when using the internal power supply P24OUT
②
when using the external power supply P24OUT
Terminal assignment for the digital inputs
X1, pin 2 (P24).
becomes too high.
Electrical specification of the digital inputs:
)
H
at V
IN H
Connectable components
12.3 PP 72/48D PN 2/2A PN
ext
min. max.
15 V 30 V
2 mA 15 mA
Nominal
24 V
-
141