Removal Of Analysis Block; Removal Of Lcd Block - Panasonic PT-AX200U Service Manual

3. Loosen the 2 screws until they idle, remove the lamp unit
with the handle.
Note:
· When installing the lamp unit (or a new one) in the
main unit, place it in a specified position and press
the connector side and the opposite side of the lamp
unit (arrow positions shown in the figure below), and
confirm the lamp unit is inserted securely.
Then, tighten the 2 screws fixing the lamp unit, and
attach the lamp unit cover.
6.9.

Removal of Analysis Block

1. Remove the lamp unit according to the section 6.8.
"Removal of Lamp Unit".
2. Remove the A-P.C.Board block according to the steps 1
All manuals and user guides at all-guides.com
17
through 4 in the section 6.3. "Removal of A-P.C.Board".
3. Unscrew the 1 screw and remove the thermofuse
attachment.
4. Unscrew the 2 screws and remove the lamp unit terminal.
5. Unscrew the 3 screws and remove the lamphouse.
6. Unscrew the 1 screw and release the grounding terminal.
7. Unscrew the 3 screws and remove the block of Analysis
Block, LCD Block and Projection Lens Block.
8. Unscrew the 2 screws and remove the LCD block.
9. Unscrew the 4 screws and remove the projection lens block
(with shift mechanism).

6.10. Removal of LCD Block

1. Remove the A-P.C.Board block according to the steps 1
through 4 in the section 6.3. "Removal of A-P.C.Board".
PT-AX200U / PT-AX200E