Engine Coolant - Mazda 2007 RX-8 Owner's Manual

RX-8_8V89-EA-06F_Edition1 Page296
Friday, May 19 2006 9:52 AM
Maintenance and Care
Owner Maintenance
5. Pull out the dipstick, wipe it clean, and
reinsert it fully.
Full
OK
Low
6. Pull it out again and examine the level.
It's OK between L and F.
But if it's near or below L, add enough
oil to bring the level to F.
CAUTION
Don't add engine oil over F. This may
cause engine damage.
The distance between L and F on the
dipstick represents the following:
Oil capacity
L (US qt, Imp qt)
NOTE
Each mark from the F mark equates
l
to about 0.5 L (US 0.5 qt, Imp 0.4
qt).
There are 3 marks between L and F.
Verify that the engine cover is
l
securely installed.
8-14
Form No.8V89-EA-06F
qInspecting Coolant Level
Do not use a match or live flame in the
engine compartment. DO NOT ADD
COOLANT WHEN THE ENGINE IS
HOT:
A hot engine is dangerous. If the
engine has been running, parts of the
engine compartment can become very
hot. You could be burned. Carefully
inspect the engine coolant in the
coolant reservoir, but do not open it.
remove the key from the ignition
switch when inspecting the engine:
Working near the electrical cooling
fan when it is running is dangerous.
You could be hit by the fan and
seriously injured.
1.7 (1.8, 1.5)
system cap when the engine and
radiator are hot:
When the engine and radiator are hot,
scalding coolant and steam may shoot
out under pressure and cause serious
injury.
Black plate (296,1)

Engine Coolant

WARNING
Turn the ignition switch off and
Do not remove the cooling