Husky HOET5201B11XUS Use And Care Manual page 10

Operation
1
Leveling Foot Adjustment
IMPORTANT : Ensure there is no weight on top of the
table before leveling.
□ Adjust each leveling foot (J) to the desired elevation with
a 5/8 in. wrench as shown.
□ Turn the lock nut counterclockwise to elevate and clockwise
to lower the leveling foot.
3
Moving the desk
□ Please unplug before moving the desk. The desk top will
be lifted up a little bit if you move the desk by holding the
wood top. It is suggested to hold the bottom leg by one
hand and hold the wood top by the other hand.
2
Adjusting the height of the wood top
□
Please connect with electricity before operation.
□
To raise the table surface, press the up button until it reaches
the desired height or the highest position.
□
To lower the desk surface, press the down button until it
reaches the desired height or the lowest position.
□
M1to M4 buttons are for saving working heights for the table. To
save a preferred height, raise the work surface to the desired
height and then press and hold any of them for three seconds until the
red light flashes three times. When the light turns blue, the setting
has been saved. Saved heights can be readjusted at any time.
10