Honda 2010 Ridgeline Owner's Manual page 342

Lights
Replacing a Front Turn Signal/
Hazard/Parking Light Bulb
1. To change the passenger's side
bulb, start the engine, turn the
steering wheel all the way to the
left, and turn off the engine. To
change the driver's side bulb, turn
the steering wheel to the right.
HOLDING CLIPS
2. Use a flat-tip screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
338
BULB
SOCKET
3. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
4.
socket. Push the new bulb straight
into the socket until it bottoms.
2010 Ridgeline
5. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
6. Turn on the lights to make sure
the new bulb is working.
7. Put the inner fender cover in place.
Install and lock each holding clip
by pushing on the center.