Honda 2010 Ridgeline Owner's Manual page 341

CONNECTOR HOLD-DOWN WIRE
WEATHER SEAL BULB
1. Remove the electrical connector
from the bulb by pulling the
connector straight back.
2. Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
3.
wire from its slot. Pivot it out of
the way, and remove the bulb.
4. Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
5. Install the rubber weather seal
over the back of the headlight
assembly. Make sure it is right
side up.
2010 Ridgeline
6. Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
Lights
337