Table of Contents
Advertisement
HEATED WASHER FLUID
(if equipped)
Slide and release the
(Heated
Washer Fluid) switch on the
multifunction lever to start four
automatic heated wash/wipe cycles.
The first cycle may take up to 45
seconds to occur before the washer
fluid is heated. The remaining cycles
may take up to 20 seconds to occur.
The system determines the amount
of fluid and activates the wipers.
Slide and release the switch again to
cancel any remaining cycles.
D
T
Performance &
Maintenance
S
T
®
– STABILITY CONTROL
TABILI
RAK
SYSTEM
StabiliTrak is an advanced computer-
controlled vehicle stability
enhancement system that assists with
directional control of the vehicle in
difficult driving conditions. It turns on
automatically every time you start
your vehicle.
When the system senses a
discrepancy between your intended
path and the direction the vehicle is
actually traveling, it selectively
applies brake pressure at any one of
the wheels to help steer the vehicle
in the direction in which you are
steering.
To limit wheelspin, you should
always leave the system on. If your
vehicle becomes stuck and rocking
the vehicle is required, the system
should be turned off.
To turn off the system, press the
traction control button located on the
center console. For vehicles without a
center console, the button is located
at the end of the gearshift lever.
S
RESETTING THE OIL LIFE SYSTEM
The Oil Life System calculates engine
oil life based on vehicle use and
displays CHANGE ENGINE OIL in the
Driver Information Center (DIC) when
it's necessary to change your engine
oil and filter. The Oil Life System
should be reset to 100% only
following an oil change.
To Reset the Oil Life System:
1. Turn the key to On, with the
engine off.
2. Press the
until the DIC displays ENGINE OIL
LIFE.
3. Press and hold the
button until 100% ENGINE OIL
LIFE is displayed.
4. Turn the key to Off.
(Information) button
(Set/Reset)
Advertisement
Table of Contents
