Planar VM Series User Manual page 50


Position
o Select the location of this display within the tiled wall.
o Options: Varies depending on the values of H Monitors and V Monitors
o Default: 1

Frame Comp. Top / Bottom / Left / Right
o Select the number of lines/pixels to remove from each edge of the display to
compensate for the display's bezel.
o Options: 1~100
o Default: 1

Frame Comp.
o Scale the image to compensate for the width of the display's bezel. Use the
Frame Comp. Top / Bottom / Left / Right controls to determine how much of the
image should be removed on each edge.
o Options: Off, On
o Default: Off

Enable
o Apply the tiling mode settings to the display.
o Options: Off, On
o Default: Off

Switch On Delay
o Select the amount of time to delay before turning on the display. Depending on
the electrical capabilities at the installation site, it can be necessary to adjust the
power on sequence of the displays. Use this control to ensure that each display
will power on at a different time, avoiding such problems.
o Options: Off, Auto, 0.1~25.0 seconds in 0.1 second increments
o Default: Off

Save To Preset
o Select a preset for saving the tiling parameters.
o Options: 1~10
o Default: 1

Save Action
o Save the tiling parameters to the selected preset.

Recall From Preset
o Select a preset for restoring the tiling parameters.
o Options: 1~10
o Default: 1

Recall Action
o Recall the tiling parameters from the selected preset.
Off Timer

Force the display to enter standby mode after the specified period of time. Press
to select the desired level.

Options: Off, 1~24 hours

Default: Off
Planar VM Series User Manual
020-1357-01D
Operating the Display
 
or
Page | 50