Kenwood DNX997XR Instruction Manual page 113

Ñ
3-way speaker system setup
● DNX997XR / DNX697S
Subwoofer Preout
Mid Range Preout
Tweeter Preout
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
Power amplifier
(optional
accessory)
Input
White
+
White/Black
Gray
+
Gray/Black
Green
+
Green/Black
Purple
+
Purple/Black
Speaker impedance: 4-8 Ω
NOTE
• For speaker system setup, see 3-way speaker
system setup (P.95).
• For speaker setup and crossover setup, see
Speaker / X'over setup (P.96).
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.113) and Connecting
wires to terminals (P.112).
Speaker
To mid range left
speaker
To mid range right
speaker
To tweeter left speaker
To tweeter right
speaker
Ñ
Connecting the system and
external components
9 8
1
2
3
AV Audio output (ø3.5 mini jack)
1
2 FM/AM antenna input
When connecting to an external amplifier,
3
connect its ground wire to the car's chassis to
avoid damaging the unit.
Rear Audio Preout
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
Subwoofer Preout
(Left; White, Right; Red)
SiriusXM Connect Vehicle Tuner connector
4
For more information on how to install the
SiriusXM Connect Vehicle tuner, consult the
installation guide included with the tuner.
5 iDatalink connector
This jack accepts either AV-IN or camera input.
6
For more information, see To set up the
camera assignment settings (P.85).
[DNX997XR / DNX697S :]
Accessory -: Mini plug to RCA cable*
or CA-C3AV (optional accessory)
[DNX577S :]
CA-C3AV (optional accessory)
Connection/Installation
13
12
11
10
7 6 5
4
1
English
113